Auxiliary Handle - Festool RS 100 Q Manual De Instrucciones Original

- Secure an abrasive sheet in place using the two
clamping devices (1.10, 3.2). Press the levers to
release the clamping devices.
Once clamped in position, make sure the
abrasive paper is taut and sits fl at on the
sanding pad.
4.4

Auxiliary handle

The auxiliary handle (3.1) can be set to different
positions. To do this, pull the handle forwards,
turn it to the desired position and release it again.
5 lnstructions on application
Never overload the tool by using too much pres-
sure! The best sanding results are achieved when
applying moderate pressure. The sanding perfor-
mance and quality depend mainly on the choice
of the right sanding material.
Metalworking
The following precautions are to be taken
when processing metals for safety rea-
sons:
- Pre-connect a residual current circuit-breaker
(FI, PRCD).
- Connect the machine to a suitable dust extractor.
- Clean tool regularly of dust accumulations in
the motor housing.
Wear protective goggles.
6 Accessories
The accessory and tool order number can be found
in your Festool catalogue or on the Internet under
"www.festool.com".
7 Maintenance and care
Always remove the power supply plug
from the socket before carrying out any
work on the machine.
The cool air openings in the motor casing must
always be kept clean and unobstructed to ensure
air circulation.
All maintenance and repair work which requires
the motor casing to be opened may only be carried
out by an authorised service centre.
The tool is fi tted with special motor brushes with
an automatic cut-out. When the brushes become
worn the power supply is shut off automatically
and the tool comes to a standstill.
Customer service and repair. Only
through manufacturer or service work-
shops: Please fi nd the nearest address
at:: www.festool.com/Service
Use only original Festool spare parts!
EKAT
4
Order No. at: www.festool.com/Service
5
3
2
1
8 Environment
Do not throw the power tool in your household
waste! Dispose of machines, accessories and pack-
aging at an environmentally-responsible recycling
centre. Observe the valid national regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh:
www.festool.com/reach
12