Labeling Recordings (Name Function) - Sony MDS-W1 Manual De Instrucciones

5
Press AMS or YES.
"Complete " appears for a few seconds and the
moved track begins playing back.
To cancel the Move Function
Press MENU/NO or p.
z
You can undo the Move Function
Use the Undo Function immediately after you moved
the track (see page 41).
Editing Recorded MDs
Labeling Recordings
(Name Function)
You can create titles for your recorded MDs and tracks.
Titles — which may consist of uppercase and
lowercase letters, numbers and symbols for a
maximum of about 1,700 characters per disc — appear
in the display during MD operation. You can also use
the remote to label a track or an MD (see "Labeling
tracks and MDs with the remote" on page 39).
MENU/NO
0/)
YES CLEAR
§
EJECT
≠ ±
AMS
0 ) r
·
P p
≠ AMS ±
A TIME/CHAR
Use the following procedure to label a track or an MD.
You can label a track while it is playing, pausing or
recording. If the track is recording, be sure to finish
labeling before the track ends. If the track ends
before you've completed the labeling procedure,
the characters already entered are not recorded and
the track will remain unlabeled.
1
Press MENU/NO to display EDIT menu.
2
Turn AMS until "Name" appears in the display
and press AMS or YES.
Skip this step while recording.
3
Turn AMS until "Name In" appears in the
display, then press AMS or YES.
4
Turn AMS to select "Disc" to label an MD, or to
specify the track to label.
While recording, go to Step 6.
MENU/NO
0/)
YES
§
EJECT
≠ ±
AMS
0 ) r
·
P p
≠ AMS ±
B TIME/CHAR
(Continued)
EN
37