Fitting The Waste Water Tray; (G592/G593/G594/G595/Cc663 Only); Fitting The Shelves & Floor Guards; Operation - Polar Refrigeration G590 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)
Fitting the Waste Water Tray (G592/G593/G594/G595/CC663/CD616 only)
The waste water tray comes ready to fit to the underside of the appliance.
Slide the tray into the runners situated under the appliance.
Fitting the Shelves & Floor Guards
Place one set of shelf guides on either side of the cabinet at the desired height.
1.
Slide the shelf into place.
2.
Repeat for the remaining shelves.
3.
Place the floor guards on the floor of the cabinet, ensuring the flat side is clear of the floor.
4.
Note: This is vital for ensuring correct drainage of condensation.

Operation

Storing Food

To get the best results from your POLAR appliance, follow these instructions:
• Only store foodstuffs in the appliance when it has reached the correct operating temperature.
• Do not place uncovered hot food or liquid inside the appliance.
• Wrap or cover food where possible.
• Do not obstruct the fans inside the appliance.
• Avoid opening the doors for prolonged periods of time.

Turn On

Close the door(s) of the appliance.
1.
Ensure the power switch is set to [O] and turn on at the socket.
2.
Switch on the Power [I]. The current temperature within the appliance is displayed.
3.

Control Panel

DEFROST LED
(Illuminates when defrost is activated)
DOWN button

Lock/Unlock the Control Panel

To lock the control panel:
Press and hold the UP and DOWN
1.
Pof flashes on the display and the keyboard is locked.
2.
To unlock the control panel:
Press and hold the UP and DOWN
1.
Pon flashes on the display and the keyboard is unlocked.
2.
Note:
If a button is not pressed for 10 seconds while using the control panel it times out and reverts to standby mode.
When parameters are being set the Setpoint LED will flash on the display.
UP button
buttons simultaneously for 10 seconds.
buttons simultaneously for 10 seconds.
Pon
Display Panel
SETPOINT LED
(Illuminates when parameters are being set)
DEFROST button
SET button
UK
2