Maintenance; Product Identification; Product Description; Important - CAMPAGNOLA ATRA Serie Manual De Uso Y Mantenimiento

• The same operator shall not use the tool for a prolonged time. Two operators shall alternate working for one hour and
then having a one-hour break. A prolonged use could be excessively tiring for the operator.
• When the tool is not used, select the OFF mode in the ON-OFF switch.
2.3

Maintenance

WARNING!
Before performing any maintenance operations or adjustments of the mechanical parts of the equipment, wear
protective shoes, gloves and goggles.
• Routine maintenance and repairs can be carried out only by an operator with the necessary physical and intellectual
qualifications.
Special maintenance and repairs can be carried out only by a service mechanic.
•
• Keep bystanders away when servicing or repairing the machine.
Only service mechanics are authorised to inactivate the safety devices provided on the machine when maintenance is
•
to be performed. It is their responsibility to safeguard the operators and the machine. The safety devices shall be acti-
vated as soon as the maintenance operations have been completed.
• Before any maintenance operations or mechanical adjustments are carried out, switch the tool off.
• All maintenance procedures not dealt with in this manual are to be performed at an Authorised Service Point of the
Manufacturer.
• When maintenance or repairs have been completed, the machine can be started again only if duly authorised by the
• service mechanic. The service mechanic must make sure:
- work has been completed;
- the machine runs in a trouble-free way;
- the safety devices are activated;
- no one is working on the machine.
3.1

Product identification

The tool identification details are shown in the sticker.
3.2

Product description

The mechanical head (Picture A) is the top of an electro-mechanical harvesting tool produced by the Manufacturer.
The electro-mechanical harvester is composed by three main parts: the harvesting head, the extension pole and the power
unit. For mode details, see the power unit Manual. There are different models of each of the three components, but all are
compatible in order to create the best solution for the task to be carried out.
The various combinations are indicated in par. 2.1 in the power unit Manual.
The harvesting head makes fruit fall thanks to the rakes (1) clapping and waving movement among the branches.
The two rakes (1) are made of techno-polymer and fitted with teeth (3) of plastic material. They are extremely light and
resistant and make a clapping and waving movement in order to limit vibrations and noise and to give the best harvesting
performance. The rakes are operated by a motor. The motion reaches the harvesting head by means of an extension pole
(see the power unit Manual). The mechanical head contains the cinematic mechanism operating the rakes (see Picture C),
the rakes (1) and their supports.
All information about the harvesting head and teeth operating system can be found in the manual of the chosen power unit.
WARNING!
Please remember the tool was created for the aim indicated in this manual.

IMPORTANT

The best battery autonomy performance is reached after the first 20 work hours.
3.3

Parts supplied

• Use and Maintenance Manual.
• First assistance spare parts.
3.4

Recommended use

The tool has been manufactured for olive and various kinds of fruit harvesting to be carried out according to the above-
mentioned ways and limits.
Use and Maintenance Manual – Original
Instructions Rev.: 02, Date 07/09/2021
Pag. 17