Removing Pad Driver Or Brush; Filling Solution Tank - Nobles Speed Scrub 1710 Plus Manual Del Usuario

OPERATION
FIG. 14
NOTE: Before installing pad driver or brush make sure
mounting surface is clean. A clean surface will ease
pad driver removal later.

REMOVING PAD DRIVER OR BRUSH

1. Raise scrub head to transport position. Step down
firmly on scrub head lift pedal to raise (Figure 15).
FIG. 15
2. Turn key switch on.
3. Tilt machine back on it's rear wheels.
4. While pressing the "brush release button", pull and
release the brush trigger quickly. The pad
driver/brush will automatically spin off motor hub.
If it doesn't release, repeat step (Figure 16).
FIG. 16
10
All manuals and user guides at all-guides.com
NOTE: To prevent scrub head skirt damage, always
keep machine in transport position when pad driver or
brush is not installed.

FILLING SOLUTION TANK

1. Transport machine to filling station. Raise
2. Turn off key switch.
3. Remove solution tank fill port cover.
4. Fill solution tank with 28L (7.5 gal) of clean water,
NOTE: If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
5. Add cleaning chemical. See proper dilution ratio
6. Replace solution tank fill port cover.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: Use only recommended detergents.
Machine damage due to improper detergent usage
will void the manufacturer's warranty. Contact
your Sales Representative for detergent
recommendations.
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
7. If machine is equipped with ESt (Extended
squeegee and scrub head when transporting.
60°C (140°F) maximum temperature. To fill with
bucket, use a bucket with a spout (Figure 17).
FIG. 17
instructions on chemical container.
WARNING: Do Not Use Flammable Liquids Or
Scrub) Option, the recovery tank can be partially
filled to extend scrub time.
a. Remove recovery tank lid and fill tank with 13L
(3.5 gal) of clean water, 60°C (140°F)
maximum temperature. Close lid.
b. Make sure ESt switch is turned on when
operating machine (Figure 18).
Speed Scrubt 1701 Plus (02–04)