Installing Brush Or Pad Drivers - Nobles Speed Scrub 2401 Manual Del Operador

For new and refurbished equipment and supplies visit www.southeasternequipment.net
3. Loosen two thumb knobs on squeegee assembly
and slide squeegee into slots on squeegee mount
bracket (Figure 4).
4. Tighten thumb knobs securely.
5. Connect vacuum hose from machine to squeegee
assembly (Figure 5).

INSTALLING BRUSH OR PAD DRIVERS

1. Turn main switch to the on position.
2. Make sure the scrub head is raised by turning off
the brush switch (Figure 6).
Speed Scrub 2401/2601 (04- -05)
FIG. 4
FIG. 5
FIG. 6
Home Find... Go To..
3. Turn main switch to the off position.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
4. Unfasten black latch at front of machine and hinge
open skirt housing to access motor hub (Figure 7).
5. Select recommended pads or brushes that best
meets your cleaning needs.
NOTE: Consult an authorized distributor for pad/brush
recommendations.
6. (For Pad Installation) Attach pads to pad drivers
before connecting drivers to motor hub. Secure
pads with plastic centerlock ring (Figure 8).
OPERATION
FIG. 7
FIG. 8
9