Practical Applications - Metabo HPT C 10FCG Manual De Instrucciones

English
Workpiece
Move
6mm Wing bolt
(Optional accessory)

PRACTICAL APPLICATIONS

WARNING:
∗ To avoid personal injury, never remove or place a workpiece on
the table while the tool is being operated.
∗ Never place your limbs inside of the line next to warning sign
while the tool is being operated. This may cause hazardous
conditions (see Fig. 13).
Line
1. Switch operation
The tool will not start unless the Lock-off button is pressed while the
switch is pulled back.
The Lock-off button can be engaged by pressing it from the left.
After the switch is on, the saw blade will continue to operate as long as
you pull on the switch trigger, even if you release the Lock-off button.
When the switch is released, the Lock-off button automatically disengages
to prevent inadvertent motor startup.
WARNING:
Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly start
operating, which could result in injury.
10
Stopper
(Optional accessory)
Holder
(Optional accessory)
6mm Wing nut
(Optional accessory)
Height adjustment bolt 6mm
(Optional accessory)
Fig. 12
Warning
Line
sign
Fig. 13
Lock-off button
Switch trigger
Fig. 14
2. Using the Vise Assembly (Standard accessory)
(1) The vise assembly can be mounted on either left side of the fence or right
side of the fence by loosening the 6mm wing bolt (A).
(2) The screw holder can be raised or lowered according to the height of
the workpiece by loosening the 6mm wing bolt (B). After the adjustment,
fi rmly tighten the 6mm wing bolt (B) and fi x the screw holder.
(3) Turn the upper knob and securely fi x the workpiece in position (Fig. 15).
Screw holder
6mm Wing bolt (B)
Fence
Vise shaft
6mm Wing bolt (A)
Fig. 15
WARNING:
Always fi rmly clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
CAUTION:
Always confi rm that the motor head (see Fig. 1) does not contact
the vise assembly when it is lowered for cutting. If there is any
danger that it may do so, loosen the 6 mm wing bolt (B) and move
the vise assembly to a position where it will not contact the saw
blade.
3. Cutting Operation
(1) As shown in Fig. 16 the width of the saw blade is the width of the cut.
Therefore, slide the workpiece to the right (viewed from the operator's
position) when length ⓑ is desired, or to the left when length ⓐ is
desired.
(2) Once the saw blade reaches maximum speed, push the handle down
carefully until the saw blade approaches the workpiece.
(3) Once the saw blade contacts the workpiece, push the handle down
gradually to cut into the workpiece.
(4) After cutting the workpiece to the desired depth, turn the power tool OFF
and let the saw blade stop completely before raising the handle from the
workpiece to return it to the full retract position.
ⓐ ⓑ
ⓐ ⓑ Marking
Marking
(pre-marked)
(pre-marked)
(Front view)
Fig. 16
WARNING:
∗ Confi rm that the trigger switch is turned OFF and the power
plug has been removed from the receptacle whenever the tool
is not in use.
∗ When you cut the workpiece, avoid any cutoff thinner than
the clearance between the cutting edge and the saw blade.
Otherwise, the cut-off material can enter the clearance between
the cutting edge and the saw blade and scatter around you,
resulting in an injury.
Knob
Vise plate
Work piece
Adjusting line
ⓐ ⓑ