Practical Applications - Metabo HPT C 10FCH2 Manual De Instrucciones

ø12 Hole
Laser line
Move
Groove
Laser marker
Laser line
Left
Right
Hex socket
bolt
Hex bar wrench
(Accessories)
Fig. 17
(3) After adjusting the position of the laser line, draw a right-angle ink line on
the workpiece and align the ink line with the laser line. When aligning the
ink line, slide the workpiece little by little and secure it by vise at a position
where the laser line overlaps with the ink line. Work on the grooving again
and check the position of the laser line. If you wish to change the laser
line's position, make adjustments again following the steps from (1) to (3).
Marking
(pre-marked)
Fig. 18
NOTE:
Check and make sure on a periodic basis if the position of the laser
line is in order. As regards the checking method, draw a right-angle
ink line on the workpiece with the height of about 1-1/2 in. (38mm)
and the width of 3-1/2 in. (89mm), and check that the laser line is
in line with the ink line [The deviation between the ink line and the
laser line should be less than the ink line width (0.5mm)]. (Fig. 18)

PRACTICAL APPLICATIONS

WARNING:
∗ To avoid personal injury, never remove or place a workpiece on
the table while the tool is being operated.
∗ Never place your limbs inside of the line next to warning sign
while the tool is being operated. This may cause hazardous
conditions (see Fig. 19).
4mm Hex.
bar wrench
Turn
Laser holder
Gear case
Laser line
Warning
Line
sign
Fig. 19
1. Switch operation
The tool will not start unless the Lock-off button is pressed while the
switch is pulled back.
The Lock-off button can be engaged by pressing it from the left.
After the switch is on, the saw blade will continue to operate as long as
you pull on the switch trigger, even if you release the Lock-off button.
When the switch is released, the Lock-off button automatically disengages
to prevent inadvertent motor startup.
Lock-off button
Trigger switch
Fig. 20
WARNING:
Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly start
operating, which could result in injury.
2. Using the Vise Assembly (Standard accessory)
(1) The vise assembly can be mounted on either the left fence {Fence (B)}
or the right fence {Fence (A)} by loosening the 6mm wing bolt (A).
(2) The screw holder can be raised or lowered according to the height of
the workpiece by loosening the 6mm wing bolt (B). After the adjustment,
fi rmly tighten the 6mm wing bolt (B) and fi x the screw holder.
(3) Turn the upper knob and securely fi x the workpiece in position (Fig. 21).
Screw holder
6mm Wing
bolt (B)
Fence
Vise shaft
6mm Wing bolt (A)
Fig. 21
WARNING:
Always fi rmly clamp or vise to secure the workpiece to the fence;
otherwise the workpiece might be thrust from the table and cause
bodily harm.
English
Line
Knob
Vise plate
Work piece
11