Practical Applications - Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones

English
Marking
(pre-marked)
Fig. 21
NOTE:
Check and make sure on a periodic basis if the position of the laser line is in order. As
regards the checking method, draw a right-angle ink line on the workpiece with the height
of about 25/32" (20mm) and the width of 5-29/32"(150mm), and check that the laser line is
in line with the ink line [The deviation between the ink line and the laser line should be less
than the ink line width (0.5mm)]. (Fig. 21)

PRACTICAL APPLICATIONS

WARNING:
1. Switch operation
Lock-off button
Switch trigger
Fig. 23
WARNING:
16
(3) After adjusting the position of the laser line, draw a right-angle ink
line on the workpiece and align the ink line with the laser line.
When aligning the ink line, slide the workpiece little by little and
secure it by vise at a position where the laser line overlaps with the
ink line. Work on the grooving again and check the position of the
laser line. If you wish to change the laser line's position, make
Laser Line
adjustments again following the steps from (1) to (3).
* To avoid personal injury, never remove or place a workpiece on the table while
the tool is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is
being operated. This may cause hazardous conditions (see Fig. 22).
Warning Sign
Line
The tool will not start unless the Lock-off button is pressed while the switch is
pulled back.
The Lock-off button can be engaged by pressing it from the left.
After the switch is on, the saw blade will continue to operate as long as you pull
on the switch trigger, even if you release the Lock-off button.
When the switch is released, the Lock-off button automatically disengages to
prevent inadvertent motor startup.
Never lock the Lock-off button in depressed position.
Pulling back the switch would then cause the tool to suddenly start operating,
which could result in injury.
Warning Sign
Fig. 22
Line