baltur BTL 3 Manual De Instrucciones página 27

INSTALLING ON BOYLER
WITH FIXED FLANGE:
- insert screw (A) in flange (B);
- Fasten flange (B) on to boiler with screws (D) (n°4 screws)
placing the insulation gasket (E);
- Insert burner into flange / boiler and fasten to screw (A) with
nut (C).
WITH SLIDING FLANGE:
- Fasten flange (B) to the boiler with n°4 screws (D) placing the
insulation card (E);
- Insert burner into flange / boiler and tighten screw (A) with nut
(C).
ELECTRIC CONNECTIONS
The electrical lines should be at an adeguate distance from hot parts.
It is advisable to make all the connections with flexible elecric wire.
Conductor's minimun section 1,5 mm .
2
7 / 14
0006080735_201104
C A U T I O N : w h e n a t t a c h i n g t h e b u r n e r t o t h e f l a n -
g e p o s i t i o n t h e c o m b u s t i o n h e a d a x i s a s
illustrated in the diagram
E
N
G
L
I
S
H
(angle α).