When playing a CD-R or CD-RW
• Use only "finalized" CD-Rs or CD-RWs.
• Some CD-Rs or CD-RWs may not play back
on this unit because of their disc
characteristics, and for the following causes:
– Discs are dirty or scratched.
– Moisture condensation on the lens inside
the unit.
– The pickup lens inside the unit is dirty.
• CD-RWs may require a longer readout time
since the reflectance of CD-RWs is lower
than that of regular CDs.
• Do not use following CD-Rs or CD-RWs:
– Discs with stickers, labels, or protective
seal stuck to the surface.
– Discs on which labels can be directly
printed by an ink jet printer.
Using these discs under high temperatures or
high humidity may cause malfunctions or
damage to discs. For example,
– Stickers or labels may shrink and warp a
disc.
– Stickers or labels may peel off so discs
cannot be ejected.
– Print on discs may get sticky.
Read instructions or cautions about labels and
printable discs carefully.
Changing the source
• If you change the source, playback also stops
(without ejecting the disc).
Next time you select "CD" for the playback
source, disc play starts from where it has
been stopped previously.
48
ImageLink
• ImageLink will not work in the following
cases:
– If no <jcl> file is included in an MP3/
WMA folder.
– If Intro Scan is activated.
– If the source is changed to another from
"CD."
• If more than one <jcl> file are included in a
folder, a file with the youngest file number is
used for the graphic screen.
Ejecting a disc
• If the ejected disc is not removed within 15
seconds, the disc is automatically inserted
again into the loading slot to prevent it from
dust. (Disc will not play this time.)
○ ○ ○ ○ ○ ○ ○ ○ ○
Sound Adjustment
Selecting the DSP modes—DSP
• Effectiveness of "V.Cancel" depends on the
recording condition of the sources.
Especially, if you play back the following
sources you cannot get the satisfactory
results.
– Monaural sources such as AM and
monaural FM broadcasting programs,
– Multiplex sound sources, and
– Sources recorded with duets, strong echo, a
chorus, or only a few instruments.
• If "V.Cancel" is selected, CCC, BBE, and
preset sound modes (EQ) will not be adjusted
("Fix" appears on the display.)
• When "4ch" is selected, rear speakers are
used only to reproduce reflections and
reverberations in order to creates a being-
there feeling in your car compartment.
• If fader or balance has been set close to its
extreme, appropriate effect may not be
obtained.
—Daily Use