Teka SL P60 4G Manual De Instrucciones página 39

1) BURNERS
A diagram is screen-printed above each knob on the
front panel. This diagram indicates to which burner
the knob in question corresponds. After having
opened the gas mains or gas bottle tap, light the
burners as described below:
- Manual ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
place a lighted match near the burner.
- Electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress and release the ignition button.
- Automatic electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1), then
depress the knob.
- Lighting burners equipped with flame failure
device
The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the full on position (large flame fig.
1) and come to a stop. Now depress the knob in
question and repeat
operations.
Keep the knob depressed for about 10 seconds
once the burner has ignited.
Closed
Position
Maximum
Setting
the previously indicated
Minimum
Setting
FIG. 1
USE
HOW TO USE THE BURNERS
Bear in mind the following indications in order to
achieve maximum efficiency with the least possible
gas consumption:
- Use adequate pans for each burner (consult the
following table and fig. 2).
- When the pan comes to the boil, set the knob to
the reduced rate position (small flame fig. 1).
- Always place a lid on the pans.
Burners
Ultra rapid
Rapid
Semirapid
Auxiliary
37
Power
Pan Ø in cm
Ratings (kW)
3,35 24 – 26
3,00 20 – 22
1,75 16 – 18
1,00 10 – 14
FIG. 2