Teka SL P60 4G Manual De Instrucciones página 43

IMPORTANT:
Always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
3) HOT PLATE
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps "A", "B" and
"C" and the burner heads "T" (see fig. 8 and 8/A)
with lukewarm soapy water. Following this, all parts
should be thoroughly rinsed and dried. Never wash
them while they are still warm and never use
abrasive powders. Do not allow vinegar, coffee, milk,
salted water, lemon or tomato juice from remaining
in contact with the enamelled surfaces for long
periods of time.
FIG. 8
CLEANING
WARNINGS:
Comply with the following instructions, before
remounting the parts:
- Check that burner head slots have not
become clogged by foreign bodies.
- Check that enamelled burner cap "A", "B"
and "C" (fig. 8 and 8/A) have correctly
positioned on the burner head. It must be
steady.
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hot plate.
- Do not force the taps if they are difficult
open
assistance service for repairs.
- Correctly preserve the plate after use by
treating it with special products, easily
available on the market. This will keep the
surface of the plate clean and bright. The
operation will also prevent the formation of
rust.
- Don't use steam jets for the equipment
cleaning.
41
or close. Contact
FIG. 8/A
the technical