Electrical Connection - Teka SL P60 4G Manual De Instrucciones

9) ELECTRICAL CONNECTION

The electrical connections of the appliance must
be carried out in compliance with the provisions
and standards in force.
Before connecting the appliance, check that:
- The electrical capacity of the mains supply and
current sockets suit the maximum power rating
of the appliance (consult the data label applied
to the underside of the hot plate);
- The socket or system has an efficient earth
connection in compliance with the provisions
and standards in force. The manufacturer
declines all responsibility for failing to comply
with these provisions.
When the appliance
electricity main by a socket:
- Fit a standard plug suited to the load indicated
on the data label to the cable. Fit the wires
following figure n.13, taking care of respecting
the following correspondences:
Letter L (live) = brown wire;
Letter N (neutral) = blue wire;
Earth symbol
- The power supply cable must be positioned so
that no part of it is able to reach an over
temperature of 75 K.
- Never use reductions, adapters of shunts for
connection since these could create false
contacts and lead to dangerous overheating.
INSTALLACION
is connected
= green - yellow wire.
When the appliance is connected straight to the
electricity main:
- Install an omni polar circuit-breaker between the
appliance and the electricity main. This circuit
breaker should be sized according to the load
rating of the appliance and possess a minimum
3 mm gap between its contacts.
- Remember that the earth wire must not be
interrupted by the circuit-breaker.
- Alternatively, the electrical connection may also
be protected by a high sensitivity differential
circuit- breaker.
You are strongly advised to fix the relative yellow
green earth wire to an efficient earthling system.
to the
WARNINGS:
The installer should bear in mind that the mixed
appliance is the Y. The rear wall, adjacent and
surrounding surfaces must therefore be able to
withstand an over temperature of 75 K.
All our
manufactured in compliance with European
standards EN 60 335-1 and EN 60 335-2-6 plus
the relative amendments.
The appliance complies with the provisions of
the following EEC Directives:
- 89/336
electromagnetic compatibility.
- 73/23 + 93/68 regarding electrical safety.
FIG. 13
44
appliances are
+ 92/31 + 93/68
designed and
regarding to