Teka SL P60 4G Manual De Instrucciones página 44

TECHNICAL INFORMATION FOR THE
INSTALLER
Installation, adjustments
maintenance must only be carried out by a
qualified engineer.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or by
his duly authorized dealer.
4) INSTALLING THE HOT PLATE
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children's reach since they could become
potential sources of danger.
The measurements of the opening made in the top
of the modular cabinet and into which the hot plate
will be installed are indicated in either fig. 9. Always
comply with the measurements given for the hole
into which the appliance will be recessed (see
fig. 10).
The appliance belongs to class 3 and is therefore
subject to all the provisions established by the
provisions governing such appliances.
FIG. 9
INSTALLATION
of controls
not be considered
FIG. 10
5) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from getting into the cabinet. Strictly comply
and with the following instructions in order to correctly
apply this seal:
- Detach the seals from their backing, checking
that the transparent protection still adheres to
the seal itself.
- Overturn the hot plate and correctly position seal
"E" (fig. 11) under the edge of the hot plate itself,
so that the outer side of the seal perfectly
matches the outer edge of the hot plate. The
ends of the strips must fit together without
overlapping.
- Evenly and securely fix the seal to the hot plate,
pressing into place with the fingers and remove
the strip of protective paper from the seal and
set the plate into the hole made in the cabinet.
- The prospective walls (left or right) that exceed
the working table in height must be at a
minimum distance from the cutting as mentioned
both in the columns and the scheme.
- In order to avoid accidental touch with the
overheating bottom of the hob, during the
working, is necessary to put a wooden insert,
fixed by screws, at a minimum distance of
50 mm from the top (see fig. 9)
COMPLY WITH THE DIMENSIONS (mm)
4B &
3B+1P
FIG. 11
42
A B C
570 480 58,5
D E
58,5 163,5 min.
FIG. 12