Disc Playback; Playing Discs Or Files - Pioneer X-CM52BT-K Manual De Instrucciones

06

Disc playback

Chapter 6:
Disc playback

Playing discs or files

1 Press STANDBY/ON to turn the power on.
The selected input is displayed on the front panel display.
• When playing discs or files, turn the TV on and switch TV
input before starting.
• You can change the screen display language of the unit
(Display settings on page 36).
2 Press DVD/CD on the remote control or
INPUT repeatedly on the main unit to select
DVD/CD input.
Please wait until you see the "NO DISC".
When a disc is already on the disc tray, press
to eject the disc.
CLOSE
3 Press OPEN/CLOSE to open the disc tray.
4 Place the disc on the disc tray, label side up.
5 Press OPEN/CLOSE to close the disc tray.
6 Press to start playback.
20
En
CAUTION
• Do not place two discs in one disc tray.
• Do not play discs of special shapes (heart, octagon, etc).
It may cause malfunctions.
• Do not push the disc tray whilst it is moving.
• If the power fails whilst the tray is open, wait until the
power is restored.
• Be sure to place 8 cm disc in the middle of the disc tray.
Note
• Due to the structure of the disc information, it takes longer
to read the disc has written by many files than a normal CD
(approximately 20 to 90 seconds).
• When the beginning of the first track is reached during fast
reverse, the unit will enter the playback mode.
OPEN/
• Rewritable multi-session discs with unfinished writing, can
still be played.
• If TV or radio interference occurs during DVD/CD
operation, move the unit away from the TV or radio.
Tip
• When no operation has done in DVD/CD mode and the
audio file is not played for more than 20 minutes, the
power will automatically turn off. In this case it is
required that the Auto power off is switched to ON.
• Auto power off can be switched to On/OFF (page 44)