Design And Function; Operating Elements And Displays; Operating Panel And Display; Details On The Device - CASO DESIGN TC 3500 Thermo Control Manual Del Usuario

14 Design and Function

This chapter provides you with important safety notices on the design and function of the
device.

14.1 Operating elements and displays

14.1.1

Operating panel and Display

1 Display of the selected setting
2 Selection button (-), reduction of the power level, temperature or duration
3 Selection button (+), increase of the power level, temperature or duration
4 Button Thermo Control (TC)
5 Button Level
6 Button Temperature (Temp.)
7 Button Timer
8 On/Standby button
14.1.2

Details on the device

This instruction and when "H" is displayed, is to warn that the ceramic hob may
still be hot. Although the induction cooker itself does not generate any heat
during the cooking process, the temperature of the cooking utensil does heat the hob!
ATTENTION Risk of burning due to hot surface!
Adhere to the following safety instructions in order to avoid being burnt by the hot
appliance:
► Do not touch the surface of the ceramic hob while it is still hot ("H" is displayed)
► Do not place any objects on the hot ceramic hob.
14.1.3

Signal Tones

The appliance emits an acoustic signal after being switched on and in the event of a fault.
14.1.4

Overheating Protection Facility

The appliance is equipped with an overheating protection facility. If the temperature of the
appliance exceeds the critical limit the error message "E05" is displayed. For safety
reasons the appliance shuts off further power supply. After the cooling-down phase the
appliance can be switched off and then back on again.
► You will find more detailed information on error messages in the chapter entitled
„Fault indications".
Please note
40