Operating The Appliance; Switching On; Power Mode; Temperature Mode - CASO DESIGN TC 3500 Thermo Control Manual Del Usuario

► If the appliance is unused for extended periods of time, we recommend that the
appliance be unplugged from the mains.

15.4 Operating the Appliance

15.4.1

Switching On

Plug the power plug into a suitable outlet.
Is the temperature of the surface of the induction cooker lower than 50°C, the display
shows „L". When the temperature of the cooker plate surface is over 50 °C, it is displaying
„H". An acoustic signal sounds. Now the device is in standby mode.
Place a suitable cooking pot with its contents to be cooked on the centre on the hob (Ø
140 mm - 240 mm). Now press the On/Standby switch to turn on the device.
15.4.2

Power Mode

 Press the button 5 (Level). The preset power stage "8" is selected and the device turns
on. With the + / - buttons, you can change the settings at any time in a range from 1 –
12.
Please note
► We recommend to select the function "Power Mode" with levels form 1-12 in case of
steaming food or boiling water for example.
15.4.3

Temperature Mode

Internal Thermometer:
 Press the button 6 (Temp.) to select the temperature. The preset temperature stage
"120°C" is selected and the device turns on.
 You can change the setting with + / - buttons at any time in a range from 60 – 240°C.
(Temperature stages: 60, 70, 80, 90, 100, 120, 140, 160, 180, 200, 220 and 240°C).
 Internal Thermometer: The temperature is measured by a sensor below the glass
ceramic plate, therefore the displayed temperature can deviate from the temperature
in the pot. Different cookware can lead to different results of measurement.
► For precise cooking, we recommend using the enclosed external thermometer.
External Thermometer – control of temperature inside the cooking vessel:
► Attach the holder at pot and insert the external thermometer.
Hang the thermometer into the cooking vessel and press button 4 (TC). When the
thermometer is connected then it measures and controls continuously the temperature
according to the desired temperature setting. After start of heating process the display
Please note
Please note
Please note
43