Saving The Program Against Changes; Switching Off; Menu Design - HEBU medical HBS x-touch 300 argon BiSeal Instrucciones Para El Uso

HBS x-touch 300 argon BiSeal

6.10 Saving the program against changes

By touching the lock on the display the current program will be protected against changes.
Nevertheless it is possible to change settings during surgery. Once the device is switched off, the
settings at the time of activation the lock will be restored.

6.11 Switching off

After terminating the operation, switch off the system at the main switch and pull out the plug.
After switching off the system, all electrodes and forceps must be disconnected from the cable and
the electrode cable from the unit.

6.12 Menu design

When a handle or a foot switch is activated, the LCD display lights up in yellow (for CUT) or blue (for
COAG), a signal sounds and a dot appears next to the selected operating mode. In the case of faults,
the display lights up red and a signal also sounds. If a vessel is sealed successful in the operating
®
mode BiSeal with AutoStop function a message will appear.
Examples of menu illumination:
"Ready" mode
"MONOPOLAR1- COAG" mode
Display: Error!
®
"MONOPOLAR1 - CUT" mode
Display: „Vessel sealing finished"
– Biseal mode
EN
51