Gaggia Milano ANIMA PRESTIGE Instrucciones De Uso página 29

Problem
Frothed milk is cold.
The milk does not
contain froth.
The "INTENZA+" filter
icon is shown on the
display after the filter
has been replaced.
The "INTENZA+" filter
cannot be inserted.
There some water
under the machine.
4219-450-03601 MANUAL GAG. ANIMA CLASS-PREST. EN-ES-PT.indd 29
Cause
The cups are cold.
The milk carafe is dirty or it has not
been inserted correctly.
The milk dispensing spout is
completely open.
The milk carafe has not been
mounted with all its parts.
The type of milk does not produce
froth.
The RESET has not been confirmed
through the machine menu.
Remove air from the filter.
The tank still contains some water.
You have tried to install a filter other
than "INTENZA+" filter.
The rubber O-ring is not connected
to the "INTENZA+" filter.
The drip tray is too full and has
spilled over.
The machine has not been placed
on a horizontal surface.
ENGLISH
Solution
Preheat the cups using hot water.
Clean the carafe and ensure to place and insert
it correctly.
Check that the milk dispensing spout is in its
right position.
Ensure that all components (especially the milk
tube) have been correctly mounted.
The amount and the quality of froth vary
depending on the type of milk. We have tested
the following types of milk and obtained
satisfying results of froth: semi-skimmed or
whole cow's milk, soy milk and lactose-free
milk. We have not tested other types of milk
because they may produce a scarce amount
of froth.
Confirm the activation of the filter using the
machine menu (see "Enabling the "INTENZA+"
filter").
Let air bubble flow out from the filter.
Empty the water tank before installing the filter.
"INTENZA+" filter is the only one that can be
inserted into the machine.
Check the O-ring packaging and connect it to
the "INTENZA+" filter.
Empty the drip tray when the indicator appears
though the tray. Always empty the drip tray
before starting the descaling procedure.
Place the machine on a horizontal surface
so as that the "drip tray full" indicator works
correctly.
29
03/12/2018 15:01:37