What To Do If The Descaling Procedure Is Interrupted - Gaggia Milano ANIMA PRESTIGE Instrucciones De Uso

ENGLISH
24
4219-450-03601 MANUAL GAG. ANIMA CLASS-PREST. EN-ES-PT.indd 24
10 Remove the container, empty it and put it back under the coffee dispensing
spout. Press OK to confirm.
11 The second stage of the cleaning cycle starts, that is the rinse cycle. This stage
lasts for 3 minutes. The display shows the rinse icon and the duration of this
stage.
Note: if the water tank is not filled up to CALC CLEAN level, it may be necessary to
repeat the rinse cycle.
12 Wait until the machine does not dispense water anymore. The descaling
procedure is finished when the display shows a tick.
13 To exit the descaling cycle, press the OK button. The machine starts warming
up and performs an automatic rinse cycle.
14 Remove the container and empty it.
15 Perform the "Weekly Cleaning of the Milk Carafe" operation to clean the carafe
after the descaling.
16 Clean the brew group as described in the "Brew Group Cleaning under Running
Water" chapter.
17 Install a new "INTENZA+" filter into the water tank.
Note: the "INTENZA+" filter reduces the frequency of the descaling clean.

What to do if the descaling procedure is interrupted

You can exit the descaling procedure pressing the STAND-BY button on the control
panel. In case the descaling procedure stops before its completion, perform the
following operations:
1 Empty the water tank and wash it thoroughly.
2 Fill the water tank using running water up to the CALC CLEAN level indication
and switch on the machine again. The machine will warm up and perform an
automatic rinse cycle.
3 Before preparing any beverage, perform a manual rinse cycle. To perform a
manual rinse cycle, dispense half a tank of hot water, then prepare 2 cups of
pre-ground coffee without adding ground coffee.
Note: if this operation is not complete, it is necessary to perform another descaling
procedure as soon as possible.
03/12/2018 15:01:34