Ryobi RTS10 Manual Del Operador página 17

TO INSTALL THE HANDLE
See Figure 9.
 Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.
 Place the nylon nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.
 Slide the handle, screw, and washer into the hole on the
height/bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
TO REMOVE/REPLACE THE THROAT PLATE
See Figure 10.
 Lower the blade by turning the height/bevel adjusting
handwheel counterclockwise.
 To remove the throat plate, place your index finger in
the hole and lift the front end pulling the throat plate out
toward the front of the saw.
 To reinstall the throat plate, slip the tab into the slot at
the back of the saw and push down to secure in place.
ASSEMBLY
NYLON
NUT
17 - English
WASHER
HEIGHT/BEVEL
ADJUSTING HANDWHEEL
THROAT
PLATE
HANDLE
SCREW
Fig. 9
Fig. 11
Fig. 10