TO USE THE MITER GAUGE
See Figure 29.
The miter gauge provides greater accuracy in angled cuts.
For very close tolerances, test cuts are recommended.
There are two miter gauge grooves, one on either side of
the blade. When making a 90° cross cut, you can use either
miter gauge groove. When making a beveled cross cut (the
blade tilted in relation to the table) the miter gauge should be
located in the groove on the right so that the blade is tilted
away from the miter gauge and your hands.
The miter gauge can be turned 60° to the right or left.
Loosen the lock knob.
With the miter gauge in the miter gauge groove, rotate
the gauge until the desired angle is reached on the scale.
Retighten the lock knob.
HEELING (PARALLELING) THE BLADE TO THE
MITER GAUGE GROOVE
See Figures 30 - 32.
WARNING:
The blade must be parallel to the miter gauge groove so
the wood does not bind resulting in kickback. Failure to
do so could result in serious personal injury.
Do not loosen any screws for this adjustment until you
have checked with a square and made test cuts to be sure
adjustments are necessary. Once the screws are loosened,
these items must be reset.
Unplug the saw.
Remove the blade guard and anti-kickback pawls. Raise
the blade by turning the height/bevel adjusting handwheel.
Mark beside one of the blade teeth at the front of the
blade. Place a combination square even with the front
of the saw table and the side of the saw blade as shown
in figure 31.
Turn the blade so the marked tooth is at the back.
Move the combination square to the rear and again
measure the distance. If the distances are the same, the
blade is square.
OPERATION
ADJUSTING
SCREWS (2)
28 - English
MITER
GAUGE BODY
MITER
GAUGE
RIGHT MITER
GAUGE GROOVE
ADJUSTING
SCREWS (2)
COMBINATION
LOCK
KNOB
Fig. 29
COMBINATION
SQUARE
Fig. 30
SQUARE
Fig. 31