To adjust (horizontally and vertically):
Remove the anti-kickback pawls and blade guard
assembly.
From the back of the saw, loosen the screws holding the
mounting bracket.
Reposition the riving knife left or right as needed to align
the riving knife with the saw blade.
Once properly aligned, securely retighten all screws.
Check again for squareness and continue to adjust if
needed.
HORIZONTAL ADJUSTMENT
RIVING
KNIFE
BLADE
VERTICAL ADJUSTMENT
RIVING
KNIFE
BLADE
ASSEMBLY
PUSH STICK STORAGE
See Figure 18.
Insert the push stick storage screws from the loose parts
bag into the holes on the side of the saw table. Use a
Phillips head screwdriver to tighten screws securely.
Place the slots in the push stick over the screws and slide
the push stick toward the back of the saw.
FRAMING
SQUARE
FRAMING
SQUARE
Fig. 17
21 - English
PUSH STICK STORAGE
SCREW(S)
PUSH STICK
Fig. 18