Ryobi RTS10 Manual Del Operador página 26

TO CHANGE BLADE DEPTH
See Figure 25.
The blade depth should be set so that the outer points of
the blade are higher than the workpiece by approximately
1/8 in. to 1/4 in. but the lowest points (gullets) are below
the top surface.
 Turn the bevel lock lever to the right.
 Raise the blade by turning the height/bevel adjusting
handwheel clockwise or lower it by turning the handwheel
counterclockwise.
TO CHANGE BLADE ANGLE (BEVEL)
See Figure 26.
This table saw has a rack and pinion bevel control that allows
you to make angled cuts from 90° to 45°.
NOTE: A 90° cut has a 0° bevel and a 45° cut has a 45° bevel.
 Unplug the saw.
 Loosen bevel control by turning bevel lock lever all the
way to the left. If it needs to be further loosened, pull
spring-loaded bevel lock lever out and rotate it back to
the right. Release bevel locking lever and allow it to seat
(lock) in its original position. Turn it to the left again until
loose.
 Move the height adjusting handwheel to the right to bevel
to 45° bevel angle.
 Tighten bevel control by turning bevel lock lever to the
right. If it needs to be tightened more, pull the spring-
loaded bevel lock lever out and rotate it to the left. Then
release bevel lock lever and allow it to return to its original
position. Rotate to the right again. Repeat this process
until bevel lock lever is securely tightened.
TO ADJUST THE BEVEL INDICATOR
See Figure 27.
If the bevel indicator is not at zero when the saw blade is at
90°, adjust the indicator by loosening the screw and setting
it at 0° on the bevel scale. Retighten the screw.
OPERATION
90º ADJUSTMENT
SCREW
TO DECREASE
ANGLE
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
SCREW
26 - English
GULLET
45º ADJUSTMENT
SCREW
TO INCREASE
ANGLE
Fig. 25
BEVEL
LOCKING
LEVER
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
Fig. 26
COMBINATION
SQUARE
BEVEL
LOCKING
LEVER
BEVEL
INDICATOR
Fig. 27