Working With The Machine - Festool RTSC 400 Li Manual De Instrucciones

face (e.g. when sanding along a wall or a window),
thus preventing back-kick of the machine, or ma-
chine damage.
Push the edge protector into the groove on the
machine.
Slot the two ends of the edge protector into
place until they click.
Loosen both ends of the edge protector.
Remove the edge protector by pulling it for-
wards.
DTSC 400 Li
1
WARNING
Risk of injury

Always secure the workpiece in such a manner
that it cannot move while being machined.
Observe the following instructions:
– Do not overload the machine by pressing with ex-
cessive force! The best sanding results are
RTSC 400 Li
6
2

Working with the machine

achieved with moderate application pressure.
The sanding capacity and quality are mainly de-
pendent on the selection of the correct abrasive.
– Work in corners and on edges tends to subject
the tip to increased stress and results in in-
creased heat development. In such cases, work
with reduced contact pressure.
– Hold the machine with one hand on the handle
[1-8].
1
4
6
2
3
15