vated under load and not yet under no-load
speed due to low power consumption.
Insert the mains adapter [3a]
Connect the mains adapter and plug-it cable
[3b]
Remove the mains adapter [3c]
Detach the mains adapter from the plug-it cable
[3d]
3a
2
1
1
3c
2
WARNING
Risk of injury
When working on power tools, always remove
the batteries or disconnect the mains adapter
first.
Electronics
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Temperature cut-out
To avoid the motor overheating, the power con-
sumption is limited at an excessive motor tempera-
ture. If the temperature continues to rise, the pow-
er tool switches off and can only be switched on
again once the motor has cooled sufficiently.
Constant speed
12
3b
1
2
3d
2
1
Settings
The preselected motor speed is kept constant
through electronic control. This means that, if the
machine is used as intended (reasonable contact
pressure), a constant sanding speed is achieved.
Setting and adjusting the speed
The speed can be set [1-5] between 6000 and
-1
10000 min
using the adjusting wheel.
For sanding, we recommend the following settings
for the adjusting wheel [1-5]:
Sanding work
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered surface
prior to paintwork
– Intermediate sanding of paintwork on sur-
faces
Adjusting
wheel set-
ting
5 - 6