Start Up Instructions - Garland MULE 961 QG Manual De Instrucciones

English

6. START UP INSTRUCTIONS

6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
A) Machine.
B Y F) Milling cutter set.
C) Outer spur holder.
D) Transportation wheel.
E) Handlebar.
G) Handle wing nut.
H) Espolón.
I) Muelle rueda de transporte.
J) Washer.
K Base of dented handle.
L) Inferior bar of the handle.
M) Plant-protecting plates.
N) Outer protector.
O) Inner spur holder.
Instruction manual.
Carefully inspect the product to ensure that there are
no damaged elements. If you find any damaged or
missing parts, do not use the machine until the defect
has been repaired or all the missing pieces replaced.
Using the machine without all of its parts or with
defective parts can cause severe personal injury.
6.2. ASSEMBLY
6.2.1. INSTALLATION OF THE SPUR
Place the inner spur holder (O) to the chassis of the
machine using the M8x50 screws (T1) included with
the machine. Open up bolt (T2) by removing the circlip
(T3).
Loosen the screw (T5) and
the nut (T4) and place the
spur (H) adjusting to the
required height. Tighten the
screw (T5) and the nut (T4).
42/184
Place the outer spur
holder (C) and close
up bolt (T2) fixing it
with circlip (T3)