Fitting The Harness; Starting / Stopping The Engine - Stihl HT 250 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English

Fitting the Harness

The type and style of the
harness/shoulder strap depend on the
market.
Shoulder Strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap.
N
With the power tool attached, the
N
carabiner (2) must be at about the
same height as your right hip.
22
Starting / Stopping the
Engine
Controls
1
2
1
Throttle trigger lockout
2
Throttle trigger
3
Slide control
Positions of slide control
4
STOP-0 – engine off – ignition is
switched off
5
F – normal run position – the engine
is running or can start
6
START – ignition is switched on –
the engine can start
Symbol on slide control
7
Starting
7
4
N
N
5
3
N
6
N
1
N
g if the engine is cold
e for warm start – also use this posi-
N
Cranking
N
h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Press down the trigger lockout lever
and squeeze the throttle trigger
and hold them in that position.
Move the slide control to START
and hold it there.
Now release the throttle trigger,
slide control and trigger lockout in
that order. This is the starting
throttle position.
9
8
Set the choke knob (8) to:
tion if the engine has been running
but is still cold.
Press the manual fuel pump
bulb (9) at least five times – even if
the bulb is already filled with fuel.
Remove the chain guard.
HT 250

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido