Fitting The Harness; Switching On - Stihl HTE 60 Manual De Instrucciones

3
5
4
Make a loop (3) in the extension
N
cord.
Pass the loop (3) through the
N
opening (4).
Slip the loop (3) over the hook (5)
N
and pull it tight.
Connect the extension cord plug to
N
a properly installed wall outlet.
HTE 60

Fitting the Harness

A shoulder strap may be used if required
(special accessory).
The type and style of the shoulder strap
depend on the market.
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the spring hook (2) is level with your
right hip when the machine is
attached.

Switching On

1
Make sure you have a secure and
N
firm footing.
Hold the machine with both hands –
N
right hand on the handle housing –
left hand on the drive tube.
Stand upright – hold the machine in
N
a relaxed position and always on
right side of your body.
Do not rest the saw chain and guide
N
bar on the ground.
Press down the starting lockout
N
lever (1) and hold it in that position.
Squeeze the trigger switch (2).
N
English
47