Maintenance; Trouble Shooting - Skil PWRCORE 20 IW5739-00 Manual Del Propietário

MAINTENANCE

WARNING
Service
WARNING
cause serious hazard . We recommend that all tool service be performed by a Skil Factory
Service Center or Authorized Skil Service Station.
General Maintenance
WARNING
NOTE: Periodically inspect the entire product for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this
product until all missing or damaged parts are replaced. Please contact customer service or
an authorized service center for assistance.
Cleaning
WARNING
Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects through openings.
WARNING
ammonia and house hold detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.

TROUBLE SHOOTING

Problem
Tool will not start.
LED light rapidly
flashes.
16
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance .
Preventive maintenance performed by unauthorized personnel may
result in misplacing of internal wires and components which could
When servicing, use only identical replacement parts. Use of any other
parts could create a hazard or cause product damage.
The tool may be cleaned most effectively with compressed dry air. Always
wear safety goggles when cleaning tools with compressed air .
Certain cleaning agents and solvents damage plastic parts . Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery pack is depleted.
2. Tool is over-loaded.
3. Battery pack is over
temperature.
4. Battery pack is not installed
properly.
5. Burned out switch.
1. Tool is over-loaded.
2. Tool is over-temperature.
Remedy
1. Charge the battery.
2. Release the variable-speed trigger
switch and try again.
3. Turn off the impact wrench and cool
the battery pack under air flow.
4. Confirm that the battery is locked
and secured to the tool.
5. Have the switch replaced by an
Authorized SKIL Service Center or
Service Station.
1. Release the trigger switch.
2. Cool the tool under air flow.