Led Lamp With Capacity Indicator; Warning Signals; Service And Maintenance - Festool TXS Manual De Instrucciones Original


The speed of the machine depends on how far
the on/off switch is pressed in.
9.2

LED lamp with capacity indicator

The LED bulb [1-10] lights up when the ON/OFF
switch is pressed [1-6].
After releasing the ON/OFF switch [1-6] the capac-
ity indicator on the LED lamp [1-10] displays the
state of charge of the battery pack for a few sec-
onds:
100%
0%
9.3 Bit store [1-11]
Magnetic, for storing bits and bit holders.
9.4

Warning signals

Power tool shuts down, capacity indicator flashes:
Battery pack is empty.

Change the battery pack.
Power tool shuts down, capacity indicator does
not flash: Power tool is overheating or has been
overloaded.

Apply a lesser load to power tool.

Allow power tool to cool down.

10 Service and maintenance

Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
70 - 100%
40 - 70%
15 - 40%
< 15%
Recommendation:
Charge battery pack
before further use.
Information on battery packs
– Store in a cool, dry place at a temperature be-
tween 5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave empty battery packs in a charger
disconnected from the mains power supply for
longer than one month. Danger of deep dis-
charge!
– If you intend to store li-ion battery packs for lon-
ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).
– To avoid short circuits the battery pack should be
stored in the packaging supplied.
11 Environment
Do not dispose of the device in house-
hold waste! Recycle devices, accesso-
ries and packaging. Observe applica-
ble national regulations.
EU only: In accordance with European
Directive on waste electrical and electronic equip-
ment and implementation in national law, used
electric power tools must be collected separately
and handed in for environmentally friendly recy-
cling.
Return used or faulty battery packs to your local
specialist retailer, Festool after-sales service or
nearest public waste management facility (observe
applicable regulations). Batteries must be dis-
charged on return. Battery packs will then be recy-
cled.
EU only: In accordance with the European Directive
on batteries and implementation in national law,
defective or used battery packs/batteries must be
collected separately and handed in for environmen-
tally friendly recycling.
Information on REACh: www.festool.com/reach
12 Transport
The lithium-ion batteries are subject to the require-
ments of the legislation on hazardous goods. A li-
ion battery pack alone falls below the applicable
limit value and certified as per UN manual ST/SG/
AC.10/11/rev. 3 part III, subsection 38.3. However,
dangerous goods regulations may apply when sev-
eral battery packs are transported For shipping by
third parties (e.g. air transport or freight forward-
ing company) special requirements with regard to
packaging and labelling must be observed. For the
preparation of the package an expert on hazardous
goods must be consulted. Please observe any fur-
ther national regulations.
TXS
GB
15