Pit Boss PRO Serie Montaje Y Operación página 26

ErP Error Code Unit Not Turned Off
Properly When Last
Connected To Power
Power Outage While
Unit In Operation
ErH Error Code The Unit Has
Overheated, Possibly
Due To Grease Fire Or
Excess Fuel
ErL Error Code Grill fails to perform
start-up cycle
Grill will not stay lit
Err Error Code with Lack Of Fuel, Poor Fuel
PELLET Error Code Quality, Obstruction In
Blinking Feed System, Jammed
Auger
Err Error Code with Ignitor is not working
IGNITOR Error Code properly, not making a
Blinking connection
Ignitor failure
Err Error Code with Auger not primed
AUGER Error Code
Blinking
Auger motor is jammed,
not making connection
Err Error Code with Fan is not working
FAN Error Code properly, not making a
Blinking connection
26
Safety feature prevents an automatic restart. Press the Power Button to turn the unit off, wait two
minutes, then press the Power Button to turn the unit on again. Turn to desired temperature. If error
code still displayed, contact Customer Service.
Press the Power Button to turn the unit off, and allow grill to cool. Follow Care and Maintenance
instructions. After maintenance, remove pellets, and confirm positioning of all component parts. Once
cooled, press the Power Button to turn the unit on, then select desired temperature. If error code still
displayed, contact Customer Service.
Check proper positioning of cooking components. Check hopper for sufficient fuel or if there is an
obstruction in the feed system. Remove pellets and follow Care and Maintenance instructions. Check
grill probe. Confirm if actual temperature is correct and accurate. Follow Care and Maintenance
instructions if dirty. Check ignitor positioning and that it is heating up properly. In extreme cold, the
grill may require a second start. Turn grill off, wait, then turn on again. Check fan. Ensure it is working
properly. Follow Care and Maintenance instructions if dirty.
Check hopper to check that fuel level is sufficient and replenish if low. Should the quality of wood
pellets be poor, or the length of the pellets too long, this may cause an obstruction in the feed system.
Remove pellets and follow Care and Maintenance instructions.
Remove cooking components from the main barrel. Press the Power Button to turn the unit on and
inspect the igniter. Visually confirm that the igniter is working by placing your hand above the burn
grate and feeling for heat. Visually confirm that the igniter is aligned with the hole in the burn grate,
and open to light the pellets. If not operating properly, call Customer Service for assistance or a
replacement part.
Igniter needs to be replaced. Contact Customer Service for replacement part.
Before the unit is used for the first time or anytime the hopper is completely emptied out, the auger
must be primed to allow pellets to fill the burn pot. If not primed, the igniter will timeout before the
pellets ignite. Follow Hopper Priming Procedure .
Remove cooking components from the main barrel. Press the Power Button to turn the unit on and
inspect the auger feed system. Visually confirm that the auger is dropping pellets into the burn pot. If
not operating properly, call Customer Service for assistance or a replacement part.
Check fan. Ensure it is working properly and air intake is not blocked. Remove hopper access panel
(see Electric Wire Diagram for diagram), and check for any damage to the fan wires. Follow Care and
Maintenance instructions if fan blades are dirty.