Installing Flat Panel Screen To Wall Plate - PEERLESS Paramount PT640 Instalación Y Montaje

Mounting and Removing Flat Panel Screen
WARNING
• Always use an assistant or mechanical lifting equipment
to safely lift and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount. Tighten screws to 40 in. • lb
(4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen from
the bottom.
3 Tension Adjustment of Ratchet Handle:
tension in tilt brackets (BB & CC) by rotating
ratchet handle. NOTE: If obstruction prevents
ratchet handle from rotating, pull handle out while
turning will allow handle to reposition without
tightening. Release and turn handle to tighten or
loosen.
Mounting Screen: Ratchet handle must be in the
up or down position or interference will occur while
hooking tilt brackets to wall plate (AA). Slowly hook
tilt brackets (BB & CC) onto wall plate (AA) and
swing screen down as shown in fig. 3.1. Tilt bracket
hooks must fully engage wall plate as shown in
detail 1. Using phillips screw driver, turn safety
screws on tilt brackets (BB & CC) clockwise till
screw tip securely contacts wall plate as shown in
cross section.
Screen Adjustment: Screen can be adjusted
horizontally by loosening safety screws on tilt
brackets (BB & CC) three full turns with phillips
screw driver. Adjust screen as shown in fig. 3.2.
Tighten safety screws on tilt brackets till screw tip
securely contacts wall plate as shown in cross
section.
Removing Screen: To remove screen from mount,
loosen safety screws, swing screen away from
mount, and lift screen off of mount.
Adjusting the Tilt Angle of the Flat
Panel Screen
4
For preset tilt angles use
custom tilt angle use ratchet handle.
INCRELOK™: The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°,
locator hole to find tilt position hole and tilt screen
to align holes. Tighten IncreLok™ tilt locking
screws on both tilt brackets to lock tilt as shown in
detail 2.
Ratchet Handle: Loosen ratchet handle (refer to
step 3 for tension adjustment of handle).
pull from top or bottom of screen to adjust tilt as
shown in fig. 4.1. The tilt can be adjusted to a
maximum of 15° forward or 5° backward.
Visit Peerless website at www.peerlessmounts.com
Adjust
Increlok™ and for
10° or 15°. Use
Push or
8 of 24
AA
DETAIL 1
AA
SAFETY
SCREW
CROSS SECTION
IncreLok™
TILT LOCKING
SCREW
TILT
POSITION
HOLES
DETAIL 2
ISSUED: 10-31-07 SHEET #: 202-9242-2 03-20-08
For customer care call 1-800-729-0307 or 708-865-8870
All other brand and product names are trademarks or registered trademarks of their respective owners.
BB &
CC
RATCHET
HANDLE
BB &
CC
fig 3.2
LOCATOR
HOLE
RATCHET
HANDLE
fig 4.1
© 2007, Peerless Industries, Inc. All rights reserved.
fig 3.1