Publicidad
Purge Valve Installation
A gas purge valve is available to protect the pump bearings against
particulate and corrosive gases that could move into the pump.
To install the gas purge valve it is necessary to unscrew the purge
port cover as shown in the following figure,
Figure 33
and then screw the gas purge valve (with a torque of 2.5 Nm) as
shown in the following figure.
Figure 34
TwisTorr 404 FS User Manual / 87-901-048-01
Technical Information
Purge Valve Installation
17
305/328
Publicidad
Capítulos
