Mounting The Loop Handle - Stihl FC 91 Manual De Instrucciones

Always walk forwards when cutting,
N
do not pull the unit towards you.
Cut at a steady pace to avoid having
N
to make several passes.
1
Use the gunning sight (1) to line the
N
blade up with the edge of the bed.
FC 91

Mounting the Loop Handle

Your new power tool comes with the
loop handle mounted on the drive tube,
but it must be turned and lined up to suit
your requirements.
Adjusting the Loop Handle
1
Use the combination wrench to
N
loosen the screw (1).
Turn the handle to the vertical
N
position.
A
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 6 in (15 cm)
Slide the handle to the required
N
position.
Tighten down the screw with the
N
combination wrench so that the
handle cannot be rotated on the
drive tube.
English
15