Ki Mobility ROGUE XP Manual De Instrucciones Y Garantía página 30

V. SET UP & USE OF YOUR WHEELCHAIR
K. Replacing the Camber Tube
4. To install the camber tube on your Rogue XP wheelchair:
a. Starting on either left or right side of chair slide end of new camber tube through camber
clamp. If your chair does not have a Standard or Dynamic 5th wheel to skip step c on next
page.
b1.) Instructions for installing Standard 5th wheel receiver on camber tube.
1. Slide 5th wheel receiver onto end of camber tube that has already been inserted
through the camber tube clamp. Receiver should be below camber tube with notched
face towards rear of chair.
2. Slide camber tube into the opposite side camber clamp.
3. Slide receiver to center of camber tube and align hole in tube and receiver.
4. Insert 5mm bolt (Fig. 18:A) into aligned hole. Secure with 5mm nut using a 3mm hex
wrench and 8mm wrench to tighten securely.
5. Using a 4mm hex wrench, tighten the 2.5mm socket head screws securely (Fig. 18:B).
Move to step c on the next page.
b2.) Instructions for installing Dynamic 5th wheel receiver on camber tube.
1. Slide 5th receiver onto end of camber tube that has already been inserted through the
camber tube clamp. 5th wheel receiver should be below camber tube with threaded
barrel facing front of chair.
2. Slide camber tube into the opposite side camber clamp.
3. Slide receiver to center of camber tube and align two holes in tube and two holes in
receiver (Fig. 18:A).
4. Insert 6mm socket head screws (Fig. 18:A) into aligned holes. Secure with 6mm lock-
nuts and flat washers and tighten securely using a 4mm hex wrench and 10mm
wrench. Move to step c on the next page.
C
E
D
Fig. 18
A
B
28