Bb. Upholstery Fabric; Cc. Adjusting And/Or Growing Seat Upholstery - Ki Mobility ROGUE XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR

BB. Upholstery Fabric

a. You must immediately replace seat and back upholstery that has worn through and shows
signs of failing. If you fail to do so, the seat or back may fail.
b. The seat sling material will weaken over time. Look for fraying, thin spots, or stretching of
fabrics, especially at edges and seams. This should be done weekly.
c. The repeated action of transferring to your wheelchair will weaken sling material and result in
the need to inspect and replace the seat more often.
d. Be aware that laundering or excess moisture will reduce flame retardation of the fabric.
e. Contact your wheelchair provider if you have concerns about your seat, back or feel it needs
to be replaced.
WARNING: Failure to comply with these instructions may result in damage to your wheelchair, a
fall or loss of control causing severe injury to the user or others.

CC. Adjusting and/or Growing Seat Upholstery

1. Seat upholstery tension adjustment
a. Reach under seat upholstery to find the tension adjustable hook and loop flap. This should
be located on the bottom, right side of seat upholstery.
b. Loosen Phillips head screws (Fig. 41:A) on same side of seat upholstery as tension adjust-
able flap.
c. Separate hook from loop on tension adjustable flap by pulling apart.
d. To tighten seat upholstery, pull the tension adjustable flap towards opposite side of chair. To
loosen seat upholstery, apply pressure from top of seat upholstery towards ground.
e. When seat upholstery has reached desired level of tension, press hook and loop back
together.
f. Retighten Phillips head screws (Fig. 41:A).
Fig. 41
A
47