Dd. Rogue Xp Standard 5Th Wheel (Optional) - Ki Mobility ROGUE XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR

DD. Rogue XP Standard 5th Wheel (Optional)

Ki Mobility recommends anti-tip tubes or 5th wheel for all wheelchairs.
1. Inserting and removing the standard 5th wheel
a. Press the two release buttons (Fig. 43:A) on the support tube so that both buttons are
drawn inside.
b. Insert into the support tube receiver (Fig. 43:B).
c. Rotate the support tube down until release pin buttons are positioned through the receiver
mounting holes.
2. Adjusting the position from the floor
a. The caster housing is adjustable within the support tube.
b. Remove wing nut (Fig. 44:A) from bolt holding caster housing into the support tube.
c. Slide housing to desired height and replace bolt and secure wing nut.
If the caster touches the ground, it is possible that the large rear wheels might not touch the
ground. Ki Mobility recommends setting the standard 5th wheel at least ½" above the ground.
Consider a higher position if the wheelchair is being used outdoors.
Fig. 43
B
A
49
Fig. 44
A