Adjusting Backrest Position - Ki Mobility ROGUE XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
V. Adjusting Backrest Position
1. To move the location of your Rogue XP backrest:
a. Loosen and remove two M6 flathead screws that attach the backrest plate to the frame.
Repeat on other side.
b. Grasp backrest clamp on each side and move to desired location.
NOTE: Holes in backrest bracket are in ½" increments. It is important to move both sides equally.
c. Replace bolts in backrest bracket, spacing bolts as far from one another as possible (Fig.
34:A). Tighten bolts through bracket and frame until secure. Repeat on other side.
NOTE: When backrest has been moved, adjustments to COG (see Center of Gravity Adjustment
on page 21) and seat upholstery (see Adjusting and/or Growing Seat Upholstery on page 47)
may be required. Always check rearward stability of the wheelchair after adjusting and before use.
Fig. 34
WARNING: Moving the backrest rearward can decrease rearward stability of the chair. Always
make adjustments in small increments and check the stability of your chair with a spotter to
prevent a tip-over. We recommend that you use anti-tip tubes.
A
41