Alliance Laundry Systems SF135PV Manual De Instrucciones página 41

Ocultar thumbs Ver también para SF135PV:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

17. Now program a drain step:
a. Press the Drain key. The display will read
"D-0739". Then press key 1. The display will
read "D10739".
b. Press the Enter key. The display will now read
"M---S".
c. Enter the length of time the computer will
allow the machine to drain (one minute).
Press key 1. The display will read "1M-00S",
indicating that a one-minute step has been
programmed.
18. Press the Enter key. The display will read
"0839".
19. Program a cold fill to high level:
a. Press the Cold key and the High key. The
display will read "CH0839".
b. Press the Enter key. The display will read
"M---S".
c. Enter the maximum time to allow for the fill.
In this case, five minutes is sufficient. Press
key 5. The display will read "5M-00S".
20. Press the Enter key as always after programming
a time duration. The display will read "0939",
indicating that the computer is ready for step 9.
21. For step 9, program the agitation action for
another dilution rinse.
a. Press the Wash key and key 1 to program an
action with normal reversing. The display will
read "W10939".
b. Press the Enter key. The display will read
"M---S".
c. Enter the time for the dilution rinse (three
minutes).
Press key 3. The display will read
"3M-00S".
22. Press the Enter key. The display will read
"1039", indicating that the computer is ready for
step 10.
F232101
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
23. The dilution rinse water must be drained once
again.
a. Press the Drain key. The display will read
"D-1039". Then press key 1. The display will
read "D10739".
b. Press the Enter key. The display will read
"M---S".
c. Enter the length of time the computer will
allow the machine to drain (one minute).
Press key 1. The display will read "1M-00S",
indicating that a one-minute step has been
programmed.
24. Press the Enter key to move to step 11 of the
cycle. The display will read "1139".
25. An extract step should now be programmed.
a. Press the Medium Speed key. The display will
read "MS1139", indicating a medium-speed
spin.
b. Press the Enter key. The display will read
"M---S".
c. Enter the length of time for the medium-speed
spin (one minute).
Press key 1. The display will read "1M-00S".
26. Press the Enter key. The display flashes "SDLY"
for one second. It will then read "0M-00S",
allowing the programmer to enter the time for a
slow-down delay (coast).
In a later step – to have the basket coast before
it stops, enter the desired coast time (up to
99 seconds). However, do not enter a time now.
That would cause a coast before a higher spin
speed (which will be the next step).
For no coast, press the Enter key.
Programming
39

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Sf250pvSf250pv tiltF135pvUf250pvUf250pv tilt

Tabla de contenido