Step Programming; Programming A Fill Temperature - Alliance Laundry Systems SF135PV Manual De Instrucciones

Step Programming

Programming a Fill Temperature

Table 5 lists the required procedures to produce
specific results.
Table 5 shows that when HIGH water level is
programmed, the display indicator is "H". When
MEDIUM level is programmed, the display indicator
is "M". When LOW level is programmed, the display
indicator is "L". When OVERFLOW is programmed,
the display indicator is "O".
When the Warm key is pressed, the next key pressed
will be another temperature key (Hot, Cold, or Warm)
before selecting the level.
Use the following procedure to program a fill to a
specific temperature:
1. The computer must be in the Program Mode, and
the cycle programming sequence must be ready
for the next step.
2. Press the Cold key. If this is the second step of
hypothetical cycle 25, the display will read
"C-0225". (HOT or WARM may be programmed
instead to control inlet valves during the first
three seconds of the fill. After the first three
seconds, the fill is the same regardless of the
prompt.)
Keys Pressed
Hot + Low + Enter
Hot + Med + Enter
Hot + High + Enter
Hot + Over + Enter
Cold + Low + Enter
Cold + Med + Enter
Cold + High + Enter
Cold + Over + Enter
Warm + Low + Enter
Warm + Med + Enter
Warm + High + Enter
Warm + Over + Enter
In addition to the standard fill temperatures, computer-controlled fill or overflow to a specific temperature is available.
F232101
Fill Temperature Programming
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
3. Press the key representing the desired water level
(Low, Medium, High, or Over). If High is
pressed, for example, the display will read
"CH0225".
4. Press the Heat key. The display will read either
"080F25" or "025C25", depending on whether
Fahrenheit or Centigrade is prompted.
Enter the desired fill temperature. Three digits
must be entered. If the desired temperature is less
than 100 degrees, the first digit must be 0. If
100 degrees Fahrenheit is entered, the display
will read "100F25".
The valid temperature range is 80 – 200 degrees
Fahrenheit and 25 – 93 degrees Centigrade. The
computer will not accept temperatures out of this
range. (The fill temperatures possible are
governed by the temperature of the available hot
water.)
5. Press the Enter key. The display will read
"M---S". Now assign the maximum time to be
allowed for reaching the fill level in minutes and
seconds.
6. Press the Enter key, and go to the next step in the
cycle.
The computer will attempt to maintain the temperature
within a margin of plus or minus five degrees of the
target fill temperature during such a step.
Display
"HL" 1 Hot Fill
"HM" 1 Hot Fill
"HH" 1 Hot Fill
"HO" 1 Hot Fill
"CL" 1 Cold Fill
"CM" 1 Cold Fill
"CH" 1 Cold Fill
"CO" 1 Cold Fill
"WL" 1 Hot Fill and 1 Cold Fill
"WM" 1 Hot Fill and 1 Cold Fill
"WH" 1 Hot Fill and 1 Cold Fill
"WO" 1 Hot Fill and 1 Cold Fill
Table 5
Programming
Valves Operating
47