Editing A Cycle - Alliance Laundry Systems SF135PV Manual De Instrucciones

4. Press the Enter key. The display will show
"xx25". (The "xx" here stands for the number of
times cycle 25 has been run and will be
represented by numbers in the actual display.)
The computer will remain in this step until one of
the following options has been chosen:
Press the Enter key to continue displaying the
G
cycle, OR
Press the Clear key to return to the normal
G
programming mode, OR
Press key 0 to reset the counter for this cycle
G
to zero, OR
Take the computer out of the Program Mode.
G

Editing a Cycle

To edit a cycle in memory or to change, add, or delete
a step:
1. Locate the key-operated programming switch:
On 135-pound models, the Program Mode
G
switch is located behind an access door
directly below the emergency stop button (top
right on the front panel of the
washer-extractor).
On 250-pound models, the Program Mode
G
switch is located on the back side of the
computer access door (left side of front panel
of the washer-extractor) below the computer
board.
Insert the key and turn the switch to the
PROGRAM position. The display will read
"CYC00".
2. Press the Edit Cycle key on the keypad. The
display will read "DCYC00".
3. Press the two-digit code for the cycle requiring
editing. For example, press key 2 and then key 5
to select cycle 25.
F232101
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
4. Press the Enter key. The computer will search for
cycle information for this cycle.
If no cycle information exists, the computer will
flash "NCYC25" followed by "ADD?". To add
this cycle, press the Enter key and proceed to the
Add Cycle programming mode. If adding this
cycle is not desired, press the Clear key. The
computer will then return to the normal
programming mode.
5. If cycle information does exist for cycle 25, the
computer will display "0425", for example, to
indicate that cycle 25 has been run four times. To
clear the count (reset it to zero), press key 0. The
display will then show "0025".
If clearing the count is not necessary or if it has
just been cleared, press the Enter key. The
computer will now display "HH0125", indicating
the first step of cycle 25.
6. Press the Advance key to move to the next step of
the cycle.
7. Press key 0 to back up to the previous step.
8. To access further information pertaining to each
step (for example, temperature and/or time),
press the Enter key.
If the display shows a temperature, press the
Enter key again to display the time.
9. Press the Enter key once more to advance to the
next step.
10. At any time, the programmer can put the Program
Mode switch in the RUN position, and the
computer will return to normal running mode,
provided all pertinent data for the last step edited
is entered.
Programming
45