Alliance Laundry Systems SF135PV Manual De Instrucciones página 42

Programming
27. The next step is to program a high-speed 1 spin,
the lowest of three high speeds. (Pressing the
High Speed key repeatedly when programming a
high-speed step will cause the computer display
to proceed from "H1" to "H2" and then to "H3",
the maximum-speed spin. After "H3" appears
and the High Speed key is pressed again, "H1"
will reappear.)
a. Press the High Speed key once. The display
will read "H11239".
b. Press the Enter key. The display will read
"M---S".
c. Enter a length of time for the high-speed spin
(six minutes). Press key 6. The display will
read "6M-00S".
NOTE: High-speed spin is not preceded
automatically by medium-speed spin. Medium-
speed spin only or high-speed spin 1, 2, or 3 may be
programmed.
28. Press the Enter key. The display will flash
"SDLY" for one second. ("SDLY" also displays
during the entire actual coastdown.) The display
will then read "0M-00S", inviting the
programmer to enter a time for the slow-down
delay (coast). If the application requires that the
basket coast before it stops, enter the desired
coast time (30 seconds here) and press the Enter
key. If no coast is desired, press the Enter key
only. The display will read "1339".
NOTE: A slow-down delay of 30 seconds minimum
should be programmed after each high-speed spin
if the speed is not followed by a higher speed spin
or another spin at the same speed. Longer motor
and belt life are direct benefits. All the
preprogrammed and optional cycles in this manual
reflect this practice.
40
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
29. The previous step ends the tutorial. Cycle 39,
consisting of 12 steps, has been completely
programmed.
To end the cycle, turn the Program Mode switch
located on the left side of the control module to
the RUN position and remove the key. The
display will then read "NEXT".
The programmer can now select Cycle 39 and
press the Enter key to run the cycle, if desired; or
a cycle of the programmer's own design can be
programmed.
Tutorial Cycle
Step Description
1 Hot Fill to Low Level
2 Supply 1
3 Wash 1
4 Drain 1
5 Cold Fill to High Level
6 Wash 1
7 Drain 1
8 Cold Fill to High Level
9 Wash 1
10 Drain 1
11 Medium Speed Spin
SDLY
12 High Speed Spin No. 1
SDLY
Stop Routine
Table 3
Min:sec
4:00
0:30
6:00
1:00
5:00
3:00
1:00
5:00
3:00
1:00
1:00
0:00
6:00
0:30
F232101