SATA J Serie Manual Del Uso página 19

Operation:
1. Start/stop （see Figure B） :
Press and hold the switch （1） to start the machine, and release it to stop the machine.
2.Speed regulation:
Change the force applied to the switch to regulate the rotating speed. The range of adjustment is between 0 and the maximum rotating
speed. The smaller the force is, the lower the rotating speed is. The drilling starts slowly and stably After the stable and reliable start,
press the switch fully for higher speed.
3.Speed position selection （see Figure C） :
First select the position, and then regulate the rotating speed with switch; the highest position is selected at delivery and there are three
position indicators （6） where three ones going on means the high position, two ones going on means the mid position and one going on
means the low position: Change the position once each time you press the mark.
Warning:
Do not operate at low speed for a long time by pressing the switch. Otherwise the machine will be overheating inside. Change
the rotating speed after stop.
4.Switch lock （see Figure D） :
The switch has the lock protection function which helps to avoid the accidental activation of the hand drill. Lock the machine by adjusting
the reversing yoke （2） to the center position.
5.Rotation reversing （see Figure D） :
Forward: Push the side of reversing yoke （2） marked with "
the side of reversing yoke marked with "
Warning:
The rotating speed can only be changed after the machine is completely still.
6.Installation or removal of sleeve （see Figure E） :
Caution:
When installing or removing the sleeve, be sure to confirm that the drill has been turned off and that the battery pack has
been removed.
1 ）Sleeve without O-ring and pin:
a）Install the sleeve: press it on the square driving head （1） of tool until it is fully seated.
b） Remove the sleeve: just unplug it.Gently tap it if necessary.
2 ）Sleeve with O-ring and pin:
a）Install the sleeve: Move the O-ring out of the sleeve groove, remove the pin on the sleeve, place the sleeve on the square driving
head （1） , align the hole in the sleeve with that on the square driving head, and fit the pin through the holes in the sleeve and
square driving head （1） , and then return the O-ring to the original position in the sleeve to fix the pin.
b） Remove the sleeve: please follow the reverse steps of installation.
51074
" to the end （right side） for releasing or unscrewing the screw the screw.
中文
" to the end （left side） for drilling and driving the screw. Reverse: Push
EN DE RU KO PT JA ES
19