Dmx Operation - Velleman VDPLW1308BI Manual Del Usuario

The last programme setting will be memorized.
e. Sound-active Operation
In stand-alone mode, select chase 9 and adjust the audio input level using the sensitivity control dial on the rear
panel of the VDPLW1308BI. In DMX mode, use channel 6 to select sound-active operation.
f. DMX Operation
Press the MODE button to view the DMX address setting menu.
Select the DMX starting address for the built-in controller using the UP and DOWN buttons.
Select DMX channel mode by pressing MODE button to view.
Then press F/S to enter, use UP and DOWN buttons to select.
6-channel mode
6-channel DMX control
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
There are 8 modes of self-running programs (value: 1-240) and 1 sound-active mode (value: 241-255) in channel
6.
Chase 1: 1-30
Chase 2: 31-60
Chase 3: 61-90
Chase 4: 91-120
Chase 5: 121-150
Chase 6: 151-180
Chase 7: 181-210
Chase 8: 221-240
Sound-active: 241-255
If the DMX signal exists, the signal in the display panel will flash. The built-in controller will automatically detect
the presence of a DMX signal. In order to receive a DMX signal, the built-in controller must be connected to a
DMX controller trough a 3-pin DMX cable. To mix the RGB colours using the DMX, channel 1 (rainbow) must be
OFF (0). When programming your own DMX sequences, note that channel 6 must be OFF to avoid activation of
the sound-control mode during the playback.
VDPLW1308BI
Indicates GREEN from dark to bright.
Indicates BLUE from dark to bright.
Rainbow
Red (0-255)
Green (0-255)
Green (0-255)
Strobe (1-20Hz)
Sound-active
3-channel mode
3-channel DMX control
Channel 1
Channel 2
Channel 3
4
Red (0-255)
Green (0-255)
Blue (0-255)
VELLEMAN