Setup And Installation - Velleman VDPLW1308BI Manual Del Usuario

• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Installation and Use of the VDPLW1308BI
a. Setup and Installation
Setup:
Connect the spots using the supplied DC/signal cables
and set each fixture address as illustrated.
Installation:
Make a hole of Ø162mm in the mounting spot. Make sure that the safety protection clip is as illustrated in diagram
1. Simply push the fixture in the pre-cut hole.
After the installation, check if the device is firmly fixed. Try to pull out the fixture a couple times to make sure that
the safety protection clip is pressed to the surface (see diagram 2).
VDPLW1308BI
2 VELLEMAN