Pump Models And Power Cords; Circuit Breaker Requirements - Agilent Technologies TriScroll 300 Serie Manual De Instalación Y Funcionamiento

Table 1 lists the available TS-300 pump models and
indicates the power cord to be used with each particular
pump.
Pump Model Motor Voltage
PTS03001UNIV 100-115 VAC
PTS03001UNIVEU 200-230 VAC
PTS03001UNIVUK 200-230 VAC
PTS03003UNIV 200-230 VAC
PTS03001UVPI 100-115 VAC
PTS03101UNIV 100-115 VAC
Circuit Breakers
WARNING
Protect against short circuits by install-
ing a circuit breaker of the proper
capacity.
The circuit breaker must be suitably
located and easily reached.
The circuit breaker must be marked at
the disconnecting device for the equip-
ment with the on/off symbol I/O and
meet the relevant requirements of
IEC60947-1 and IEC60947-3.
Table 2 lists the circuit breaker capacity required for pump
motors of various voltages, single and three-phase.
Table 2

Circuit Breaker Requirements

Single Phase Motor 100-115 VAC
Breaker capacity 15 Amperes
Three Phase Motor 200-230 VAC
Breaker capacity 5 Amperes
TriScroll 300 Series Vacuum Pump
Table 1
Plug Type
NEMA 5-15P
CEE 7/7
BS 1363
-
NEMA 5-15P
NEMA 5-15P
200-230 VAC
50/60 Hz 50/60 Hz
7.5 Amperes
380-415-460 VAC
5 Amperes
Three phase pumps are shipped without a power cord. A
three phase power cable kit, Agilent part number
S4789001, is available. This kit does not include a plug.

Pump Models and Power Cords

Fusing
-
-
BS 1362
13 Amp
-
-
-
Conductor Size Cord Marking
14 Gage UL/CSA
3x1.50 mm2 <HAR>
3x1.50 mm2 <HAR>
- -
14 Gage UL/CSA
14 Gage UL/CSA
Cord Length
2.5 m
2.5 m
2.5 m
-
2.5 m
2.5 m
3