Fein SLUGGER JME HoleMaker III Serie Instrucciones De Uso página 23

OBJ_BUCH-0000000375-002.book Page 23 Tuesday, March 12, 2019 9:48 AM
Switching the gear setting (figure 13).
With the gear switch, you can select the
speed and thus the torque.
Adjust the gear setting only when the
machine is at a complete stop or when the
motor is running down.
Set the switch to gear 1 to work at low speed
with high torque. This setting is suitable for
drilling with large drill bit diameters and for
tapping.
Set the switch to gear 2 to work at high speed
with low torque. This setting is suitable for
drilling with small drill bit diameters.
JME HoleMaker –
III (**)
JME USA 202 M 1. Gear
(**)
JME USA 202 M 2. Gear
(**)
Fig. 13
Max. capacity in steel Max. capacity in steel
2
with up to 400 N/mm with up to 400 N/mm
– TCT (core drill bit)
1/2 in – 1 3/8 in
12 mm – 35 mm
1 1/16 in – 2 in
27 mm – 50 mm
1/2 in – 1 in
12 mm – 26 mm
Max. capacity in steel
2
with up to 400 N/mm
– high speed steel – high speed steel
(core drill bit)
1/2 in – 1 3/8 in
12 mm – 35 mm
13/16 in – 2 in
21 mm – 50 mm
1/2 in – 13/16 in
12 mm – 20 mm
en
23
2
(twist drill bit)
1/4 in – 5/8 in
6 mm – 16 mm
5/8 in – 15/16 in
16 mm – 23 mm
1/4 in – 5/8 in
6 mm – 15 mm