the screws which secure the pointers and
adjust them so that they will point to 0°.
1
2
3
001572
(2)
45° bevel angle
1
2
001573
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm points to 45° on
the bevel scale on the arm holder. If the
pointer does not point to 45°, turn the left 45°
bevel angle adjusting bolt on the side of the
arm holder until the pointer points to 45°.
To adjust right 45° bevel angle, perform the
same procedure described above.
Adjusting for smooth beveling action
1
004860
The hex lock nut holding together the arm and arm
holder has been factory adjusted to assure smooth
beveling action and to guarantee precise cutting. Do not
tamper with it. Should looseness develop at the arm and
arm holder connection, tighten the hex lock nut using a
wrench.
1. Bevel scale
2. Screws
3
3. Pointers
1. Arm holder
2. Right 45 ゚ bevel
angle adjusting
bolt
3
3. Left 45 ゚ bevel
angle adjusting
bolt
1. Arm
2
2. Hex lock nut
Adjusting the position of laser line
For model LS1214L/LS1214FL only
1
3
006342
1
2
006343
WARNING:
As the tool is plugged when adjusting the position
•
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
Never look into the laser beam directly. Direct laser
•
beam causes damage to your eyes.
LASER RADIATION
•
Do not stare into beam.
Never apply a blow or impact to the tool. A blow or
•
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
When adjusting the laser line appears on the left
side of the saw blade
1
1. Screw to change the movable range of the adjusting
screw
2. Adjusting screw
3. Hex Wrench
4. Laser line
5. Saw blade
006345
23
1. Workpiece
2. Cutting line
3. Holder
2
1. Vertical vise
2. Holder
2
4
3
5